平板打印（Flat printing）.docVIP

平板打印（Flat printing） Is EPSON (EPSON) converting the technology of flatbed printer difficult? Why is the price of the refit so expensive? Reward points: 5 time: 2009-12-7 15:44 | | questionger: de (EPSON) Epson bleak love modified flatbed printer technology difficult? Why did the manufacturers just change a little, so the price is so expensive? What a windfall!! EPSON converted the technical principle, the network has technical guidance, but these are only part of the surface, and its core is the motherboard, chip cracking and flat drive restructuring. The principle is understood by everyone, but it is not only necessary to have a good equipment, but also need constant debugging and improvement. 1 、 refitting principle The driving signal of the paper rubbing motor is drawn out, and then a power amplifier is added to drive a larger step motor. Then the motor position to do platform, through the wire rod, synchronous belt, wire to mobile work platform or a printer body, in fact, is the paper rubbing motor is converted into the Y axis motor (control machine, ink vehicle before and after e mobile). The paper rubbing mechanism after modification of the machine itself is basically useless, without affecting the structural strength of the printer case can be removed or cut off the roller, to make the lower space to the working platform. When the printers start working, through a photoelectric sensor to check there is no paper, when a simple modification of flat-panel printers, need to move to the end of the sensor platform, to test platform is not close to the printer, the printer can detect similar paper printing state, this time, the printer will work. This sensor can be replaced by proximity switches, which makes it easier to handle the sensors mounting position. More complex is a little modification to deal with some things, such as through the microcontroller, can send virtual sensor signal to the printer paper, directly print cheat printer, printer and the host comput