南方cass地形图处理.doc

南方cass地形图处理 Topographic map said there are many kinds of landforms method in surveying the contour method is usually adopted. The contour is a closed curve refers to the same as the ground elevation of adjacent points from the collection. With the contours of landform, can not only clearly shows the ups and downs of the state of the ground, and to demonstrate the elevation of ground slope and ground point, to facilitate the planning and design of projects on the map. This paper makes a brief discussion on how to generate accurate contour. Data collected outside the industry by the total station within the industry contour generated by development of Guangzhou mapping equipment in the south of the terrain cadastral mapping software (CASS). A field data acquisition In order to make the contour mapping software to generate accurate and reasonable, outside the industry, collecting data with the total station, in addition to the landform change to point and point to Slope Transformation of vertical mirror, the scarp, as long as it is close to 90 degrees, the general should be measured in the ridge and ridge stand mirror, and record the scarp to and to the ridge. In the measurement of residential area, sometimes to stand mirror on the roof, these points can not represent the local elevation, the elevation should be zero, that is to build within the industry elevation model (DTM) is not considered the point. Generation of quality rationality directly affects the measurement experience outside the industry and the people stand mirror points within the contour of the industry, so people generally engage in the measurement of vertical mirror old engineers. Two, the contour generation When the industry after the end of the work, back to the room to start the CASS mapping software, set the communication parameters, the coordinate data of the total station came out to save the file to *.DAT format using the data transmission function of CASS software, then you can use this file