专业4（Major 4）.docVIP

专业4（Major 4） 1. what are the components of the operation monitoring device? Answer: the components are host, control box, locomotive signal, signal sensor, speed sensor, pressure sensor, electric control valve, alarm button and dump device etc.. Whats the three state of the 2. coupler? Three? Whats the function of each? Answer: locking, unlocking and unlocking. After the vehicle is connected, each coupler shall have a locking action to ensure that the coupler can not be isolated at all times during the train operation. When removing the vehicle, the coupler shall have a locking action so as to disengage the two connected coupler. The coupling of vehicles, should have the full effect of coupler lock, in which a vehicle hook tongue fully open, so that the other hook hook tongue into the hook, so that the two connecting hook. 3. how to determine the number of Bogies and axles of four axle flat cars? Answer: to brake cylinder piston rod extends out the direction for the front steering frame is corresponding to the first bogie, the front axle for the first axis, second rear axle shaft; another second bogie bogie, the front axle for third axis, fourth axis rear axle. 4. rail car in the interval after parking, if the engine flameout, how to do anti slide? Answer: the rail car was forced to stop in the interval, if the engine flameout, should tighten the rail car and attached vehicle brake in all human, and rail car ends are placed anti slide iron shoes firmly fixed. 1. briefly describe the operation process of rail vehicles. Answer: when the trailer is 5m, it must stop, and then connect. After the connection order of the following operations: pull test, air pipe, open angle cock, try the wind, loose hand brake (or iron shoes). How does the 2. track car prevent sliding when the section of the pipeline stops? Answer: in the pipeline for rail car, the vehicle should be even linked together, and tighten the front and rear ends of the vehicle brake fixed to human, iron shoe fir