砖混结构、构造柱、圈梁、板缝等混凝土施工工艺标准（Technical standard for construction of masonry structure, structural column, beam, slab and other concrete）.docVIP

砖混结构、构造柱、圈梁、板缝等混凝土施工工艺标准（Technical standard for construction of masonry structure, structural column, beam, slab and other concrete） Technical standard for construction of masonry structure, structural column, beam, slab and other concrete Range This technology is applicable to masonry structure, brick outside the inner mold plate internal mold structural column, beam, slab and other concrete pouring process. Construction preparation 2.1 materials and equipment: 2.1.1 cement: use slag No. 325~425 Portland cement or ordinary Portland cement. 2.1.2 sand: with coarse sand or medium sand, when the concrete is below C30, the mud content is not more than 5%. 2.1.3 stone: structural columns, ring with a diameter of 0.5 ~ 3.2cm pebbles or gravel; seams with a diameter of 0.55 ~ 1.2cm fine stone, when the concrete is below C30, mud content is less than 2%. 2.1.4 water: clean water without impurities. 2.1.5 admixture: according to the requirements of early strength agent, water reducing agent, etc., the amount of mixing by the laboratory to determine. 2.2 operating conditions: 2.2.1 the concrete mix is determined by the laboratory, and the proportioning notification is consistent with the materials used in the field. The 2.2.2 template is firm and stable, elevation, size meet the design requirements, a template slot exceeds the specified value, to plug tight, and finished pre screening procedures. 2.2.3 rebar through the hospital procedures. 2.2.4 structure to ring joint of loose concrete and mortar should be removed, the template debris to clean up. 2.2.5 at room temperature, before pouring concrete, brick, wood should be ahead of the amount of water, but water is not. Operation process 3.1 process: Operation preparation: concrete mixing, concrete transportation, concrete pouring, vibrating and concrete maintenance 3.2 concrete mixing: 3.2.1 according to the moisture content of sand and stone, the water consumption in the mixture ratio should be adjusted, and the number of m