自校准流程（Self calibration process）.docVIP

自校准流程（Self calibration process） Data recovery and maintenance of data hard disk in West China second Author: admin source: Date: 2011-9-27 17:07:26 popularity: 272 Tags: Data Recovery WD]PCI3000 (West data factory self check) Preparation before SelfTest Ready to run SelfTest, the working environment, prepare a separate PC power (AT power), the power supply must be connected to the PC-PC3000PCI function can be used on the card, ready to do around the SelfTest hard drive and power supply must have enough space, the hard disk must be connected to the PC-3000PCI card, suggestions on the ATA1 port; Start SelfTest function The hard disk is connected to the power supply for independent SelfTest, turn on the power, the drive is connected to the PC-3000PCI card, running Normal mode, Tools Utility, extensions, SelfTest and SelfTest start running Launch SelfTest command, after the process of initialization and operation of the first hard disk built-in test, run Interrupt status monitoring interrupt status monitoring command. The end of the SelfTest dialog box, exit the program, because the test another port also need some time. From running SelfTests hard disk, keep the power on, disconnect the data line, connect to the next hard disk, do the same step again, and continue to do SelfTest on all the hard disks. The hard disk must be completed during the always on independent power in the whole SelfTest, takes about 3-6 hours, you can use other hard disk maintenance and diagnosis of the second ports on the PC3000-PCI card during the operation, as can be connected to the #1 port call capacity hard disk monitoring, testing is complete, it will make the state signal, and then check the remaining disk. Complete the SelfTest function Sometimes, the SelfTest needs to be re adjusted to the SelfTest hard drive, connected to the PC-3000PCI card, and run the program at SelfTest Monitor mode; The SelfTest Monitor mode details are described below About SelfTest monitoring mode, on the hard