钻头磨法（Bit grinding method）.docVIP

钻头磨法（Bit grinding method） Grinding of bit Hits: 5392 release time: source: The apex angle is 118 + 2 2O The posterior horn at the margin of the hole was 10 -14 degrees The transverse edge angle is 50 degrees -55 degrees (two) the length of the main cutting edge and the two angles of the axis of the drill bit must be equal Two main flank surfaces should be sharpened and polished. But its not enough to have the theory, and make sure the students stand in front of the grinding machine automatically Hands, hands are not blind sharpening. If it is not the hand that guides the sharpening of the students hand Law and technique, then, a good student of theoretical knowledge, you let him go for the first time sharpening Nine out of ten standard twist drills must not be drilled. Why? The theory is not yet It has guiding function to practice. Students have not mastered the skills and skills of sharpening. Standard twist drills are usually used to grind only two main flank surfaces and a sharpened edge, but they are not available After sharpening, it is necessary to ensure that the top angle, the horizontal blade edge angle and the two main cutting lengths are equal, the left and right sides are equal. And, after sharpening the cross blade, the drill is cut lightly during drilling Fast, chip removal is normal, there is indeed a certain degree of difficulty. First of all, to help students build confidence, confidence and motivation. After mastering the methods and techniques, a knife is sharpened Qualified standard twist drills are not very difficult either. Secondly, we should definitely tell them to wear less, see more, blindly grind, and grind more and more blindly, and grind a long drill I still dont know why. Only by grinding less, seeing more, analyzing more and understanding more, theory will gradually guide practice. Less grinding, is to miss the point when less grinding, not even Grinding. This can save the waste caused by blind grinding, and can also concentrate on stu