冯天有新医正骨（Feng ty bone setting）.doc

冯天有新医正骨（Feng ty bone setting） Pu Ren He Feng ty bone setting manipulation For reference only 1, ring joint wrench [methods of operation] A patient sits on the low stool, head back later, the patients who stand in patients with lateral, a thumb hold top second patients with cervical vertebral spinous process, another elbow hold the patients jaw, bypassing the contralateral palm, which caught the occiput, and then gradually forced to pull out of cervical vertebra. On the basis of stretching, rotate the cervical vertebra to a resistance position, and then make a controlled, slightly increasing amplitude of the quick turn, with the thumb under the spinous process at the same time. At this point, you can often hear click, and the thumb under the thumb of spinous movements, that means success [operation essentials] 1, pull out the cervical vertebra first, then rotate again on the basis of stretching. 2, to the side of the odontoid process of rotation, the thumb will be second cervical spinous process to the side of the top press. 3, according to the strength of the patients constitution, control the rotation of strength, avoid by all means too big. This method is mainly used for the treatment of atlantoaxial subluxation. 2. Cervical oblique pulling manipulation [methods of operation] The patient was sitting, head slightly bent, neck relaxed, patients who stand in the side of the rear, with a hand behind the brain, the other hand hold the lower jaw, hands make concerted action, head to the contralateral side to the side, slowly rotating (namely the left lesion, turning to the left side to the right side lesions; rotation). When rotating to resistance, a pause for a moment, then forced to do a controlled, slightly increased significantly (about 5-10 degrees) fast move, this time also can often hear click sound, a purpose, then let go. [operation essentials] 1, according to the cervical spine lesions, in different flexion angle pull 2, when the rotation of the cervical spine