道路勘测毕业设计.docVIP

PAGE PAGE I 摘 要 本设计根据给定资料，根据该路形的性质、地形、地物、水文等自然条件的特点，依据《公路工程技术标准》(JTG B01-2006)交通部颁发的主要有关技术指标完成，在设计中全部采用最新标准和规范。完成了以下内容包括：根据给定起终点，选择合适控制点，根据等高线间距和选定的平均纵坡，初步拟定可行的路线方案，经修正，确定出满足《标准》要求的平面线形；根据《公路路线设计规范》(JTG D20-2006)规定(最大纵坡、限制坡长等)，结合控制点和经济点高程，确定路线纵断面设计线；根据公路等级和地形条件，进行路基设计；根据公路等级和交通量，确定路面结构类型并完成路面设计；以避免交通阻塞，减少交通事故为原则，进行平面交叉设计；在老师的指导下，采用公路路线CAD软件，进行计算机绘图。 关键词 路线 路基 路面 Abstract This design according to the given material. through the analysis on the original data, according to the nature of this route, topography, geophysics, hydrology and other natural conditions, according to the characteristics of the highway engineering technical standards (2003), etc B01 JTG related technical index issued by the ministry of complete in the design, all adopt the new standards and norms. Completed the following content: according to the given up end, select the appropriate control points, according to the average spacing and selected contour ZongPo, preliminary develop feasible route schemes, as amended, identify meet the standards requirements of the horizontal alignment; According to the highway route design rules (JTG D20-2006) regulation (maximum ZongPo, restricted slope length etc), combining the elevation control and economic points, to determine the route alignment design line; According to the highway rating and terrain conditions, roadbed design; According to the highway rating and traffic, determine the pavement structure types and complete the pavement design, the highway route of CAD software and computer graphics。 Keywords route Subgrade Pavement 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295636451 摘 要 PAGEREF _Toc295636451 \h I HYPERLINK \l _Toc295636452 Abstract PAGEREF _Toc295636452 \h II HYPERLINK \l _Toc295636453 第1章 绪 论 PAGEREF _Toc295636453 \h 1 HYPERLINK \l _Toc295636454 1.1选题的目的及意义 PAGEREF _Toc295636454 \h 1 HYPERLINK \l _Toc295636455 1.2 设计任务及设计依据 PAGEREF _Toc295636455 \h 1 HYPERLINK \l _Toc295636456 1.2.1 沿线自然情况 PAGEREF _Toc295636456 \h 1