ad898 training report固晶焊接机.pptVIP

(22-26)may-2006 AD898 training reprot by bo yang AD898 Training Report In ASM Shen Zhen Attend: Bo yang,Gongrong ma, jianxin ho Trainer: Bob chen(ASM engineer)day1-day4; Edward stang day 5 Period: Total 5 Day Training course content Question and corrective Conclusion Training course content AD898 introduce and profile Machine platform leveling explanation and adjustment. Optical table leveling and practices Bond head parts setup and calibration Hipec system introduction. Training course content Machine leveling and alignment procedures explanation 机器校水平和校正步骤说明 Training course content Machine platform leveling explanation and adjustment 机器平台校水平和调节 用水平仪放在机台的Workholder上,通常是放在Dispenser position and Bond position处,调整机器四个脚垫,使整机保持水平状态,先做此步才能保证后续各部分的校正动作! Training course content Optical table leveling and practices 光学系统工作台校水平和实习 Training course content Camera center setup 摄像机定中心 使镜头放大倍数至最大,并同时调整Focus至最清晰,调整十字线中心对准Pattern的一角点,镜头有三个顶丝,通过调节这三个顶丝即可调节十字线的对准位置,然后将镜头倍数缩放至最小,并使Focus最为清晰,再调节十字线至Pattern的角点上，这样反复此动作，使十字线在最大跟最小倍数上重合一点！ Training course content Camera center setup 摄像机定中心 Training course content Front track leveling with specification 按照规格校正前轨道水平 调节机器前轨道水平,使四条轨道保持同一水平面,以利送板顺畅. Training course content Bond head table leveling and alignment 焊头工作台水平校正 较正邦头整体结构Y方向的水平度,首先拆下邦头,装上校正治具,将Z轴压下,Y轴平移,观看千分表上读数,不得超过5um的公差,即2.5个刻度. Training course content Bond head table leveling and alignment 焊头工作台水平校正 如果平整度大于5um,即需要调节Y轴的水平,先拆掉Output elevator,使其Home到最后端,松开Bond head Y轴的四个镙丝 Training course content Bond head table leveling and alignment 焊头工作台水平校正 调节如下图位置所示的偏心圆镙丝,使其到一个最佳的位置,最终使千分表读数小于2.5个刻度即可. Training course content Optical table alignment with track 光学工作台与导轨校准 看光学十字线中心是否与轨道上需求对中的点中心重合,不然就需调节光学头上的X方向镙,使其中心与所需位置对中,Y方向可以Programmable控制.即Y轴Optical Offset进行调节.一般可跟据产品需求第一个Unit中心位置的需求来确定此位置. Training course content Optical table alignment with track 光学工作台与导轨校准 Training course content Workholder setup 机器轨道工作平台设置 Training course content