通力无机房电梯故障代码（Failure code of KONE elevator without engine room）.doc

通力无机房电梯故障代码（Failure code of KONE elevator without engine room） Failure code of KONE elevator without engine room Code fault name, cause, status, operation 0001 driving time is long, the position signal 30/B30 has not changed after a running time, immediately stop the switch, 0003 speeding for:v2lcedrv 0004 three consecutive failures of synchronous operation, three consecutive simultaneous operation, the system can not correctly receive the deceleration level signal, after three failures, stop at the end of the station power off 0007 door switch 308030 clamping, start a period of time, did not detect the falling edge of the 30/B30 signal, the door area switch 30/B30 has been effectively running to the target floor, the door does not take the car, power off or maintenance 0008NVRAM damage or capacity is insufficient. When power is transmitted, the capacity of NVRAM is not enough to replace NVRAM The 0014 gate check circuit does not release the 486.443; the 1.443:2 either runs 2 consecutive times (ACO/ACL) to the destination floor, leaving the service switched off The 0015 gate check circuit has no pull in 486.443; the 1.443:2 either runs 2 times continuously (ACO/ACL) to the destination floor, leaving the service off 0021 、 the safety circuit is blocked, the safety circuit is input 1, no voltage is stopped immediately, the safety circuit is switched on or in the state of electric operation. 0022 hall door lock, safety loop, enter 3, no voltage, stop the door lock immediately 0023, the car door lock is not safe, enter 2 no voltage, stop the car door lock immediately 0025 start system failure, elevator stop, the main contactor is not released, do not start the main contactor troubleshooting 0026 drive system fault drive system fault is detected (v3FCK lamp) does not start off electric or maintenance, or a thermal switch transistor v3f16es tachometer fault 0027 K7 relay to failure by physical damage caused by the relay itself or the K7 pull. The main contactor does not p