行车电脑编码（Vehicle computer code）.docVIP

行车电脑编码（Vehicle computer code） Automatic headlamp The 2 pin on the automatic headlamp switch is connected to the G519 controller E14. Two. Rain sensor The 1 leg of the rain sensor is FireWire access (the circuit is connected to the SC13, which has been occupied and is recommended to be connected to the SC17, SC13 and SC17 as a control firing line); The rain sensor is 2 feet with zero line grounding; The rain sensor 3 is connected to the G519 on the signal control line F3. Three 、 anti dazzle eyepiece in car Anti glare glasses in the car, 1 feet are FireWire access (the circuit is connected to the SC4, the insurance has been occupied, it is recommended to receive the SC5, SC4 and SC5 as a control FireWire); Anti glare glasses in the car, 2 feet for the zero line grounding; The anti glare mirror in the car is connected with the C12 on the signal control line G519 with 3 feet. The control signal line is controlled by the reversing light, and the reverse gear is used to automatically turn off the rear view and prevent glare; Four, open automatic headlight and go home, leave home function 1, open the 09 module; 2, select 07 encoding; 3, the selection of long encoding help, byte will be 0 below 5 (home function) and 6 (photosensitive, rainfall sensor (home), 7 function) tick after save and exit. 4, adjust the time, away from home, enter, 10, in the channel number in the input 01, will be the new value to 10~120 any time after completion of their preservation; then enter the channel number in the input 02, will be the new value to 10~120 any time after save yourself. Five. Turn on the windows automatically in rainy days 1, open the 46 module 2, select 07 encoding 3, change the number of tenth to 02 (the original factory is 04), start counting from the left, each of the 2 digits to one. Six. Adjust the sensitivity of automatic headlamp and sensitivity of wiper 1, open the 09 module; 2, select 07 encoding; 3, select the third item in the component drop-down box, that is, RLS