草图技巧（Sketching skills）.docVIP

草图技巧（Sketching skills） 1, when you select, double-click a separate surface, you can select the same surface and the line forming the face 2 or two times, double-click on one side of the object, you can choose the entire object surface and line 3, the use of roaming commands and camera commands, you can enter in the lower right corner of the input box to enter the height of the line of sight 4, the use of dynamic zoom command, you can enter the number of Deg (example: 60Deg) to adjust the camera angle 5, the use of dynamic zoom command, you can enter the number of Mm (example: 35mm) to adjust the camera focal length 6, the object into groups or components, you can right-click in the menu inside the axis mirror phase, select the mirror phase mode 7, select objects, scaling the command, select the direction of scaling, then enter -1, you can mirror objects 8, use push and pull command once, next time use push and pull command, double click can repeat last size 9, select the object, press and hold Ctrl, you can increase the choice, press and hold shift, you can add and subtract, select, while holding down Ctrl and shift for less choice 10, shift+ mouse middle key for pan function 11 hold the shift while locking in one direction (such as parallel, polar axis, etc.) to keep this lock 12, select the state click object is selected line or plane is double line and surface and three Click to press the CTRL object selection of vehicle mobile copy command can be directly copied object if the object has a set of words copied objects are still in the same group use eraser can only delete the line and not so if you want to delete delete face on one side of the line with a messy eraser than the marquee object after using the DEL command is convenient 13, roller + left key is pan, oh, pay attention to the wheel, press the left key. 14, in the copy movement (by CTRL copy), enter the value of x/, such as input 5/, then two objects appear between 4 objects, such as input 4/, two object