电动车充电器（Electronic Car Charger）.docVIP

电动车充电器（Electronic Car Charger） 1 、 constant current charging stage, the charger charging current remains constant, charging power increased rapidly, the battery voltage rise; 2, constant voltage charging stage, the charger charging voltage is constant, the charging power continues to increase, the battery voltage rise slowly, the charging current drops; 3, the battery is full, the charging current drops below the float switch on the current, the charging voltage of the charger to reduce floating voltage; 4, float charging stage, the charging voltage of the charger to keep floating voltage; The first important parameter is the low constant voltage value in the trickle stage. The second important parameters are the high constant voltage at the second stage, and the third important parameter is the conversion current. These three important parameters are related to the number of batteries, which are related to the capacity of the battery, Ah, and temperature, and are related to the type of battery. In order to facilitate your memory, the following are the most common electric bicycles (three 12V series 10Ah batteries) used for the three segment charger, for example, a brief introduction: The low voltage constant value of trickle phase is discussed at first, and the reference voltage is about 42.5V. This high value will cause the battery to lose water, make the battery heating and deformation easily. This value is low, it is not conducive to the battery sufficient electricity. This value is below 41.5V in the South; the gel battery is below 41.5V, as in the south. This parameter is relatively strict and can not be greater than the reference value. Secondly, the second stage high voltage constant voltage is discussed, and the reference voltage is about 44.5V. This high value is conducive to rapid charging, but easy to make the battery charging current loss, the late results get down, make the battery heat deformation; this value is not conducive to low battery fast charg