电路改造的基本知识（Basic knowledge of circuit reconstruction）.docVIP

电路改造的基本知识（Basic knowledge of circuit reconstruction） Basic knowledge of circuit reconstruction (1) basic requirements 1.1 per household should set the household distribution box, distribution box should be equipped with leakage circuit breaker, leakage current shall be less than 30mA, with overload, over-voltage protection function, and the scores of road lighting, air-conditioning outlet, respectively, socket, the loop should ensure the normal use of load. 1.2 wire laying shall be constructed according to the provisions of decoration design, short circuit protection, over load protection, wire section selection, low-voltage electrical installation should be carried out according to current national standards and the relevant provisions of Shanghai. 1.3 indoor wiring except through the hollow floor are wear pipe laying, and with good insulating single stranded copper conductor. When laying through pipes, the total cross sectional area of the pipe shall not exceed 40% of the sectional diameter of the inner diameter of the pipe, and there shall be no joints or kinks in the pipe. Wires and telephone lines, closed-circuit television lines, communication lines, etc. shall not be installed in the same pipe. 1.4 lighting and electric load line diameter section should be chosen so that the wire safety is not greater than the shunt all appliances rated current and the line capacity does not exceed the capacity of the line into the family. 1.5 grounding protection shall be reliable, and the insulation resistance between conductors and conductors shall be greater than 0.5M. 1.6 the thickness of the PVC plastic conduit pipe shall be no less than 1.2mm. 1.7 electric heater installation shall not use ordinary sockets, shall not be installed directly on combustible components. Bathroom outlet should be chosen splash proof. 1.8 sockets should be no less than 200mm from the ground. The wire in the wire box should be left with a margin, the length should be 150mm. The phase switch wi