码表906（Table 906）.doc

码表906（Table 906） BC906 manual The top right of the table is the RESET (reset) key, hereinafter referred to as the reset key The top left of the table is the SET (set) key, hereinafter referred to as the setting key Below the table is the MODE (mode 2) key, hereinafter referred to as the A key To use the new table, according to the following steps. I. initial settings Press the settings button first, and then press and hold the settings button for about 3 seconds. The main settings menu appears (the top right of the screen shows set). Set the basic steps and methods of the table: Press the A button to switch to the menu which needs to be changed, and press the settings button to enter the two level menu. At this point, the place where you can change it will flash, then press the reset button to adjust the specific parameters, then adjust the settings and then press the settings button Confirm the changes, set up, the screen will display SET OK prompt. Simple operation hints: The reset button is reset reset, the number is set, and the setting key is confirmed. When the parameter is set, hold down the settings button for about 3 seconds and return to normal use. The menu contents and main functions are as follows: 1, LANGUAGE (language settings) There are 7 languages available. Here we have ENGLISH. 2, KMH/MPH (speed unit) There are 2 speed units available. Here we have KMH. 3, WHEEL, SIZE (bicycle wheel size) Direct input to the circumference of the wheel. 4, CLOCK (clock setting) Set current time. 5, TOTAL, ODO (cycling mileage) Sets the initial value of the total ride mileage. The mileage unit is KM. 6, TOTAL TIME (bike riding time) Sets the initial value of the total ride time. 7, CONTRAST (display contrast) A total of 3 options, namely 1 (light), 2 (standard), 3 (concentrated). Here we set 2 (standard). All of the above set after the completion of the table card into the table seat, you can normally use. Two, use Press the A key to switch: 1, TRIP, DIST (single ri