神钢故障表（Kobelco fault table）.doc

神钢故障表（Kobelco fault table） Kobelco SK200-2 SK200-3 fault code A-1ROM bad data (not adjusted by electromechanical A). A-2 electromechanical A adjustment is bad. A-3CPU anomaly. B-1 large arm pressure sensor abnormal. B-2, large arm drop pressure sensor abnormal. B-3, small arm recovery pressure sensor abnormal. B-4 and small arm overhang pressure sensors are abnormal. B-5, bucket recovery pressure sensor exception. B-6 and bucket overhang pressure sensor exception. B-7, abnormal rotation pressure sensor. B-9, abnormal walking pressure sensor. B-10, left pressure sensor abnormal. C-1 and P1 oil pump pressure sensors are abnormal. C-2 and P2 oil pump pressure sensors are abnormal. D-1, P1 neutral shut-off proportional valve abnormal. D-2, P2 neutral shut-off proportional valve abnormal. D-3, straight travel proportional valve abnormal. D-4, large arm proportional valve abnormal (only -2 models). D-5, slow swing proportional valve exception (only -2 models). D-6 and small arm variable regenerative proportional valves are unusual (only -3 models). E-1 and P1 abnormal proportion valve of oil pump. E-2 and P2 abnormal proportion valve of oil pump. F-1, abnormal pressure solenoid valve. F-2, reverse brake solenoid valve abnormal. F-3, walking speed conversion solenoid valve abnormal. F-4, FC mode (micro operation) solenoid valve exception (only -2 models). F-5, straight line solenoid valve exception (only -2 models). G-1, stepper motor current abnormal. G-2, stepper motor without starting division. G-5, engine stall (show E/G reversal). Kobelco SK200-6 fault code: 1 、 mechanical and electrical controller fault. 1-1 、 the instrument and the electromechanical controller communicate abnormally. 1-2 、 abnormal battery relay. A-1, no electromechanical A adjustments. A-2, mechanical and electrical A adjustment is not good. B-1, upper arm pressure sensor abnormal. B-2, large arm drop pressure sensor abnormal. B-3, small arm recovery pressure sensor abnormal. B-4 and small arm over