组装电脑的步骤（Steps to assemble a computer）.doc

组装电脑的步骤（Steps to assemble a computer） Steps to assemble a computer.Txt DIY zanwei first step: install the CPU processor In the current market, the Intel processor adopts LGA 775 interface, both the Celeron processor entry, or the end of the Pentium E and Core 2, and even high-end quad core Core 2, the interface is LGA775, installation completely consistent Before installing the CPU, we have to open the socket first: press the press bar of CPU with proper force, and push the lever to push it out of the fixed buckle. When the lever is disengaged from the buckle, we can pull the lever smoothly The triangle notch mark on the motherboard corresponds to the CPU Special attention should be paid when installing the processor. You can observe carefully, there is a triangle mark on the corner of the CPU processor, and carefully observe the CPU socket on the motherboard, also will find a triangle logo. At the time of installation, the angle with the triangle logo on the processor is aligned with the corner with the triangle logo on the motherboard, and then the processor is gently pressed in place. This is not only applicable to Intel processors, but also applies to all current processors, especially for the pin design of the processor, if the wrong direction is unable to install CPU to the whole area, we should pay special attention at the time of installation. Put CPU on the socket of the main board Installed CPU processor After placing the CPU in place, cover the cover button and press the lever of the handler in the opposite direction. At this point, CPU is firmly mounted to the motherboard, and the installation process is over. The second step: install DIY zanwei radiator As the CPU calorific value, select a radiator with excellent heat release performance is particularly critical, but if the radiator is improperly installed, the effect of heat dissipation will be greatly reduced. The Intel pin of the LGA775 interface of the processor the original radiator, we can see the