木门检验标准（Wooden door inspection standard）.docVIP

木门检验标准（Wooden door inspection standard） Wood composite door material characteristics and inspection standards Wood is a porous material with the characteristics of dry shrinkage and moisture expansion, while the asymmetry of wood structure determines the anisotropic drying and expansion of wood. For most wood, the dry expansion of the tangential (circumferential) direction is approximately two times the radial (diameter direction), and is twenty times as long as the longitudinal direction (the direction of the trees growth). The tensile strength is just the opposite; the longitudinal is about twenty times the chord and radial. Plywood is a kind of laminated veneer made of laminated sheets, so the anisotropy of dry shrinkage, wet expansion ratio and tensile strength is greatly reduced. This is the real reason why plywood is widely used instead of solid wood. Although it is possible to solve the deformation problem by replacing large scale materials with laminated composites, the deformation of the transverse single plate can not be solved. If in the aspect on the basis of Glulam adhesive layer, and two transverse single plates, so as to solve the deformation problem, and solves the problem of transverse shrinkage and swelling, the transverse tensile strength is increased by more than ten times, but also solves the problem of transverse cracking and lateral deformation, such integrated material is called three-dimensional gluelam aspect. Indoor wood decorative materials, the material in the form of solid wood has always been the most luxurious, the most viable. Solid wood composite door series products such as door, door and so on, are based on the three-dimensional aspect Glulam (or two-dimensional vertical to the substrate, Glulam) using curved pressure (horizontal) hot pressing bonding surface, precious veneers processing, on the one hand it has the features of luxurious wood and life force, on the other hand has smaller deformation, cracking and shrinkage and swel