语音at命令参考（Voice at Command Reference）.docVIP

语音at命令参考（Voice at Command Reference） AT voice command reference.Txt21 spring blossoms! If you have ever been in winter, you will have spring! If you have faith, then spring must be far away; if you are paying, then one day you will have a full circle of flowers. Voice AT Command Reference Note: some modems dont have voice communication function. The following table lists the phonetic AT commands that your modem can understand, including the tone phone command and the TAM command. Each command description includes command names, explanations, and related parameters. Remember: your modem must operate under Microsoft Windows 95 and not work under the old version of MS-DOS or Microsoft Windows. Voice command Command description +FCLASS=8 goes into voice mode. AT+FCLASS=8 puts the modem in voice mode. The tone telephone and TAM modes are included in the universal voice mode and use specific voice mode command subsets to perform respective features and functions. The modem controller will maintain the overall state of the system in order to master the time to issue voice commands in an environment of TAM or other speech environments using the voice amplification telephone. +FCLASS? Returns the current modem mode. +FCLASS=? Returns the supported modem mode. AT+FCLASS= query the scope of the mode supported by the modem. Modem returns: 0, 1, 8, 80 (data, fax, voice, and VoiceView). +FMI modem manufacturer logo. AT+FMI? Indicates modem to identify manufacturers. +FMM modem product identity. AT+FMM? Indicates that the modem reports its own product identity. +FMR modem revision identification. AT+FMR indicates that the modem reports its own revision level or other relevant information. +VIP initializes the speech parameter. AT+VIP enables the modem to initialize all the speech parameters as default values. +VCID=n caller ID. AT+VCID enable / disable caller ID. Argument: n = 0, 1, 2 N = 0 disables caller ID N = 1 enables caller ID, which is a formatted caller Report N = 2 enable