防水卷材工艺（Waterproof roll process）.docVIP

防水卷材工艺（Waterproof roll process） First, the air laid BAC waterproof roll (mainly applicable to basement floor and other waterproof parts suitable for empty place.) Construction process: base treatment - - node strengthening treatment - - hollow laying coil - long, short side bonding bonding - quality acceptance 1) basic treatment: the base should be smooth, solid, no Mingshui, the projections clean. 2) node strengthening treatment: the nodes are strengthened according to the standard requirements. 3) the length and width of the long and short side of the material should comply with the relevant specifications. 4) long and short side bonding: a web of long and short lap edge isolation film removal, then low pressure roll compacted cement. Two, cement mortar paste BAC waterproof roll (mainly applicable to grass-roots level, no level of basement, roof, roof and other waterproof project) 1. cement mortar with paste, BAC waterproof roll The construction process: the primary treatment, with cement mortar (waterproof), off the surface of the isolation membrane, BAC waterproofing membrane under BAC waterproofing membrane, pat shop web surface, pulp, put clothes (24 to 48 hours), the interface seal to strengthen processing - node to quality acceptance 1) grass-roots treatment: the surface of the grass roots should be dealt with first, so that the grass roots are firm and clean, and they are fully moist and free from stagnant water. 2) with cement mortar: its thickness is 10 mm to 20 mm (as the case may be, grass-roots level) should be paid attention to when the shop floor and smooth compaction. In the corner of the shade, a radius of 50mm or more shall be applied to the fillet. Paving cement mortar width than the length of the coil, short edge should be 100 to 300mm width, and in the process of paving, use the guide rail to ensure flatness. 3) remove the membrane of the lower surface of the BAC waterproof roll. 4) laying BAC waterproof coiled material: BAC waterproof roll is