限位开关（Limit switch）.docVIP

限位开关（Limit switch） The realization of the two basic methods of limiting the 1 program will limit limit switch signal input to the PLC, PLC output signal control relay coil circuit, so as to realize the controlled loop motor will stop 2 limit switch connected to the relay coil, disconnect relay coil circuit, so as to realize the controlled motor stop loop Leakage protector The leakage protector is used to protect the low-voltage electric network from direct electric shock and indirect electric shock, and also can be used as the phase protection of the three-phase motor. It has one phase and three phases. Because of the leakage current or the resulting neutral point to ground voltage change for action signal, so there is no need to use electric current value setting operation value, so the sensitivity is high, the action can effectively cut off the power supply, ensure personal safety. According to the working principle of the protector, it can be divided into three kinds: voltage type, current type and pulse type. The voltage protection device is connected to the transformer neutral point and the ground, when the electric shock when the neutral point voltage offset to the real estate, in order to make the action to protect the power off, but because it is the protection of the transformer low voltage network, cannot be classified protection, so the power range is large, frequent moves, so has been eliminated. The pulse current protector is a sudden change in the phase and amplitude of the three-phase unbalanced leakage current when an electric shock occurs, which is used as an action signal, but also a dead time. The current type current leakage protector is widely used, so the protector of current type is mainly introduced below. Classification of current type leakage protector According to the action structure, it can be divided into direct action type and indirect action type. The direct action type is the action signal output, which directly acts on the release d