汽轮机超速试验（Turbine overspeed test）.docVIP

汽轮机超速试验（Turbine overspeed test） 1.2.3 flying hammer emergency safety device overspeed test 1.2.3.1 test condition: (1) after installation or overhaul of the unit. (2) the unit has been running continuously for 6 months. (3) after the disintegration or adjustment of the flying hammer type emergency protector. (4) before load rejection test. (5) after a months shutdown, start again. (6) after carrying out the generator with 10% rated load for 4 consecutive hours (the main steam superheat should be greater than 80 degrees Celsius). (7) before the test in emergency stop device, automatic main steam valve, control valve action quick, tight closure. (8) DEH works normally; (9) the vibration of the unit is normal, and the axial displacement and differential expansion are normal. (10) electric overspeed 109% protection test is qualified. (11) reheat steam temperature and vacuum are normal. (12) contact thermal engineering to remove turbine trip -MFT protection in boiler FSSS system. (13) removal of DEHs OPC and ETS overspeed protection function. (14) when test, the main steam pressure is 6.0Mpa, the main steam temperature is 4500C. 1.2.3.2 safety measures: (1) the speed of the flying hammer type emergency safety device shall be 3300-3360 r/min, the test shall be conducted two times, and the speed difference of the two movements shall not exceed 0.6%n0, and the reset speed shall be higher than the working speed of about 50 r/min. (2) the speed of the unit is up to 3360r/min, while the hammer type emergency protector is not operating. It should be stopped immediately. (3) the test switch is cut to the mechanical overspeed position on the DEH disk. (4) the unit is broken out and shall be completed within 30 min. (5) in the test, if the regulating valve is large shaking, it should stop the brake. (6) the fluctuation of the main steam temperature during the test is prohibited. (7) during the test, special personnel should be required to monitor the vibration, axial displacement