液压试题（Hydraulic examination questions）.docVIP

液压试题（Hydraulic examination questions） Chapter 1 hydraulic transmission overview I. thinking questions 1. hydraulic transmission is the law as a working principle, that the medium, in the form of energy transmission. 2., the two basic features of hydraulic transmission are:,. 3. hydraulic transmission system consists of four parts. 4. hydraulic component symbols used to indicate:. 5. hydraulic transmission system diagram is used to indicate:. 6. the operating pressure of the hydraulic transmission system depends on the operating speed of the actuator. 7. hydraulic transmission through the form of energy can be, hydraulic transmission through the form of energy is able to. 8. the power of hydraulic transmission depends on. 9. what are the advantages and disadvantages of hydraulic transmission? Two. Calculation questions 1. as shown in Figure 1 - 1, the diameter of the two hydraulic cylinder is D=12cm, and the plunger diameter is d=8cm. If the weight of the hydraulic cylinder, the plunger and the oil is omitted, the pressure oil is input from the oil port B to the hydraulic cylinder. How much pressure does the hydraulic cylinder enter to lift the weight of the 30kN? If the flow rate of the input cylinder is Q=2 l/min, how much is the speed of the two plungers? (1) (2) Figures 1 - 1, figure 1 - 2 2. there is a hydraulic jack, each part of its size as shown in Figure 1 - 2, L1=40cm, L2=10cm. The diameters of the plunger and piston are 5cm and 1cm respectively. If the top weight is G=30kN, in the Fg end of the stick force increased? 3. there is a hydraulic jack, each part of its size as shown in Figure 1 - 2, L1=100cm, L2=20cm. The piston action area is 100cm2, and the piston action area is 1cm2. If Fg=2kgf is added to the end of the rod, what is the weight G? The second chapter hydraulic pump and hydraulic motor I. thinking questions 1. hydraulic pumps are divided into three major categories. 2. hydraulic pump is to change oil absorption and discharge of oil, commonly kn