研究储存7)（Research storage 7)）.docVIP

研究储存7)（Research storage 7)） Separation of gas hydrate At the same temperature, the pressure of hydrate formation by different guest molecules is different. For example, at 0 DEG C, the formation pressures of N2, CH4 and C2H6 hydrate are 14.3, 2.56 and 1.01MPa, respectively. Accordingly, gas generated from the hydrate can be separated from the gas mixture under a given operation condition by controlling the operation temperature and pressure. The hydrate gas separating technology is not under the pressure of different gas compositions of hydrate formation and put forward, which is shown in figure 2. schematic flow control pressure to make easy composition of hydrate phase change (from gas hydrate formation by solid grass), easy separation of some gases, such as methane and ethane, methane and ethylene. Simultaneous. Due to the absence of ions and strong polar components in the Su hi nuclear weapon, the separation of water and salts, acids, alkalis, alcohols and other substances can be made by the formation of hydrates. Hydrate separation technology can be used in seawater desalination, solution concentration, gas separation and biological engineering and biological technology. Bechtel of the United States has developed a new technology for separating CO2 from the waste of coal combustion. First, by using the pressure CO2 to cause water to form water clusters can contain foreign CO2 molecules, and then injected into the exhaust stream, CO2 hydrate formed in the vicinity of high pressure and freezing point, so as to generate hydrogen from the gas hydrate can not be separated and used for combustion power generation; hydrate is transmitted to another container, by heating or pressure release CO2, water recycling. No, similar studies by the DOE show that the separation efficiency of CO2 is up to 86% and the recovery rate of hydrogen is as high as 99.8% for the waste discharged from coal burning power plants. Columbia University, Happel, et al proposed a new type of gas s