分析弯曲模的设计毕业论文.docVIP

编号： 毕业设计说明书 题 目： 负极片连续弯曲模的设计 院 （系）： 机电工程学院 专 业： 学生姓名： 学 号： 指导教师单位： 姓 名： 职 称： 题目类型：(理论研究 (实验研究 (工程设计 (工程技术研究 (软件开发 2015 年 6 月 5 日 摘 要 本次毕业设计以负极片连续弯曲模为设计对象的 1.应用绘图软件AutoCAD进行零部件设计，减少试模次数，提高生产效率，节省成本； 2.本次设计的模具采用冲孔落料弯曲级进模，节省人力，节省了工序，从真正意义上实现高效率的生产； 3.本次的设计结果是可行的，可以在具体生产中应用； 4.通过计算，凸模要加上垫板增加其强度 5.考虑了刃口的增减性，在进行冲压时，凸模刃口尺寸减小，凹模刃口尺寸增大。冲裁间隙选用最小合理间隙。 关键词：负极片；冲孔；弯曲；落料；连续模设计 Abstract The mold design is lateral support multi-position progressive die. Work piece material is QSn6.5-0.1. Negative plate for engineering actual parts, commonly used in the instrument industry, etc..In the design process in the analysis of the negative plate blanking, bending forming process, introduces the layout scheme, stamping force calculation, punch and die cutting edge size calculation, design of the main parts, die shut height calculation, mold manufacturing process.In punching, blanking, bending level in mould design process, I collected a lot of material to study die design process, with reference to the large number of about design of stamping die and stamping process books and technical data, every point of the stamping die design research, design of every parts verify its rationality and assiduously compound die design process, timely detection of problems and find the guidance teachers to solve. The plate in the mold design and the process of my strength of the mold frame, the need to add, the spring force and the unloading force compared to the corresponding calculation and selection of the check. In addition, the production conditions are verified, and the feasibility of the process is ensured, and the conditions for shortening the production cycle, saving raw materials and mass production are also ensured..The design points of the design, the following aspects of the research: 1. I applied the designing software AutoCAD into the progress of desig