打印机十大故障解决方法（Ten trouble shooting methods of printer）.docVIP

打印机十大故障解决方法（Ten trouble shooting methods of printer） First, the printer output blank paper For the printer, causes printing paper blank mostly because the ink ribbon, ribbon breaking, dry print head damage, should be replaced or repaired in a timely manner the ribbon print head; for inkjet printer, print blank caused by fault is mostly due to nozzle clogging, no ink cartridges, cleaning nozzle or should replace the cartridge for; laser printer, the cause of the fault is probably the developing roller fails to suck the toner (DC bias of the developing roller is not added), may also be the photosensitive drum ungrounded, unable to release the negative charge, can play a role in the laser beam on the photosensitive drum. In addition, the photosensitive drum of the laser printer does not rotate, and no image is generated and transmitted to the paper. Disconnect the printer power supply, remove the toner cartridge, open the slot on the box cover, and mark the non photosensitive part of the drum, and then reload it in the machine. Start running for a while, and then remove the check mark is moving, you can determine whether the drum is working properly. If the toner does not supply properly or the laser beam is blocked, printing blank paper appears. Therefore, the toner should be checked out, the cartridge is properly loaded into the machine, the sealing tape has been removed or the laser is irradiated. Is there a shield on the channel?. It should be noted that the power must be switched off when checking, as the laser beam may damage the operators eyes. Two 、 the output of printing paper is black For the printer, the cause of the fault is on the ink ribbon, ribbon hair too much, the print head dirty, poor quality and adjusting ribbon push rod position too close, maintenance should first adjust the push rod position, if the fault cannot be ruled out, and then replace the ribbon, cleaning the print head, can usually be troubleshooting for ink jet; the printer, should check