房屋验收标准（House acceptance standard）.docVIP

房屋验收标准（House acceptance standard） DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. House acceptance standard A door, check the 1. inspection standard (1) surface should be clean, no scratches and bruises; (2) the cutting angle, welds should be strictly flat; (3) the gap between door and wall caulking should be full; (4) the door making the allowable deviation: door warping allowable deviation is 3mm the doors, warping allowable deviation is 2mm, smooth surface of the door frame door allowable deviation is 2mm, the diagonal length of allowable deviation is 3mm; (5) seam limit, allowable deviation of installation: door counterpart joints, door leaf and frame and vertical seam width of 1.5 ~ 2.5mm; (6) left seam width 3.5cm should not be less than the blank room door and the ground. 2. owners how to check Ruhumen whether conforms to the standard quality acceptance of housing under normal circumstances, the owner shall be the following aspects of the door were examined: (1) check the door: door installation is firm and smooth, the frame and the wall connection is closed tightly, the door surface is often of burr, crack, breakage and so on; (2) the door check the door: no deformation, cracking, surface is intact, the surface is smooth, there is no obvious scratches, bumping into the ground, consider whether reserved ground decoration practices; (3) check: door lock locks are firmly installed, the key plug is smooth, the rotation of the lock core is freely, the direction of the lock tongue the expansion, the lock hole is normal; (4) check: open the door opening and closing is stable, there is no abnormal resistance and wear, the door is locked if there is Shake; (5) check the door handle: whether the installation is firm, rotating, whether or not the abnormal resistance, the surface has no defects, deformation; (6) seal check: door cover is in less than 2.5mm. The genera