设计类论文格式（Format of design papers）.docVIP

设计类论文格式（Format of design papers） Installation process of compressor control circuit board [Abstract] the design of circuit board is the first step to create a startup disk is an important step, according to the design of circuit board drilling well drilling, drilling method should pay attention to the correct use of transfer, and then according to the list of ingredients to choose components assembled on the board, the assembly should pay attention to the position and direction of components, tens of millions of do not put the wrong. It can be said before the work is just for the next connection as a foreshadowing. According to the circuit diagram, and then the control circuit of the line, then the main circuit of the line, must emphasize every line must be connecting with prison, the debugging work is done on the previous work of a general check. [key] design, assembly, inspection, wiring, proofreading, modification The compressor is the heart of the refrigeration system, the refrigerant gas suction pipe of low temperature and low pressure from the air, through the operation of the motor drives the piston to compress it after high temperature and high pressure refrigerant gas discharge pipe to the exhaust, to provide power for the refrigeration cycle, so as to realize the compression, condensation, expansion and evaporation (endothermic) refrigeration cycle. Compressor is usually composed of shell, motor, cylinder block, piston, control equipment and cooling system. Our company mainly produces the control circuit board in the compressor control equipment. The technical term is called: start disk. The circuit board plays a role in starting, controlling, protecting and driving in the compressor. This paper introduces the technological process of producing a compressor startup disk. The starting process of the compressor startup disk includes the following aspects: the design of the circuit board, drilling, assembly of the components, wiring and debugging. First, the