频率计汇编程序（Frequency meter assembler）.docVIP

频率计汇编程序（Frequency meter assembler） Cymometer program Include: external interrupt settings, interrupt service procedures, timing procedures, timing service procedures As well as data processing, display, including three bit decimal number into four bit BCD code, ; ------------------------------------------------------------; BEEP BIT P3.7 LCD_RS BIT P2.0 LCD_RW BIT P2.1 LCD_EN BIT P2.2 LCD_X, EQU, 3FH; LCD address variables TIMER_H EQU 30H; timer high byte unit TIMER_L EQU 31H; timer low byte unit TIMCOUNT EQU 32H; number of time interrupts INT_G EQU 35H; interrupt count buffer unit high address INT_H EQU 34H; address in the interrupt count buffer unit INT_L EQU 33H; interrupt count buffer unit low address T_S EQU 36H; data display low T_M EQU 37H; data display median T_H EQU 38H; data display high T_G EQU 39H; data display MSB ----------------------------------------------------------; ORG 0000H JMP MAIN; the main program starts ORG 000BH JMP TIMER_INT; timer T0 interrupt service routine ORG 001BH; timer T1 interrupt service routine JMP TIMER1 ORG 0030H ----------------------------------------------------------; MAIN: MOV, SP, #60H; sets the SP pointer LCALL PRO_SET; initialization CALL SET_LCD LCALL TIM_T0 -----------------------------------------------------------; The LCD1602 is a slow display device, so the 100MS is displayed once. -----------------------------------------------------------; MAIN1: MOV R5,40 MAIN2: ACALL DELAY1; 3MS DJNZ, R5, MAIN2 ACALL SBIN_SBCD CALL CONV JMP MAIN1 ------------------------------------------------------------; T1 Counter interrupt service subroutine Count the T1 counter overflow times ------------------------------------------------------------; TIMER1: INC 2AH RETI ------------------------------------------------------------; Initialization program ------------------------------------------------------------; PRO_SET:, MOV, A, #00H MOV, B, #00H MOV, 2AH, A MOV, P0, #0FFH MOV, P1, #0FFH MOV, P2, #0FFH MOV, INT_H, #00H MOV, INT_