座椅发泡工艺（Seat foaming process）.docVIP

座椅发泡工艺（Seat foaming process） Molding process for polyurethane production Zhang Jing, Yuan Guoyuan, Sun Tianbao (Zhengzhou Yutong Bus Limited by Share Ltd, Henan, Zhengzhou 450061) Abstract: This paper introduces the molding method of automobile polyurethane cushion and the influence of foam density on its service performance. Key words: automobile; cushion; molding; foam density; opening degree Abstract:, This, paper, introduces, themould2plasticsmethod, ofmaking, the, vehicle, polyurethane, seat,, cushion, and, the Effect, of, the, seat, cushion, foamdensity, on, the, performance., using Key words:V ehicle; Seat cushion; M ould2plastic; Foamdencity; Hole density CLC number: TQ 320166, document identification code: B, article number: 100623331 (2003) 0320029202 The automobile industry is an important industry in our country. Chinese car in 2001 Production and marketing has broken through millions of vehicles. The seat and backrest are made of ammonia Ester production, the current production methods are mainly heat curing and cold cooked Two kinds of chemicals. With the improvement of living standards, peoples comfort to the seat Higher requirements are also put forward, in this regard, cold ripening is more mature than heat There are advantages, but each has its advantages and disadvantages. The following main discussion about them Foaming methods and their differences. 1, car seat cushion can be adopted molding method 111 thermal molding process Thermal molding began in the mid 70s, using TD I (toluene two) Isocyanates and lower reactive polyols require higher temperatures And longer stripping time, so the energy consumption is large and the cycle is long. In addition, by the system Foam, resilience and comfort of the product are poor. The advantages of hot moulding foam The utility model has the advantages of high carrying capacity and low density of products, so that the utility model does not need to be improved Mechanical treatment of mechanical crushing by foa