电工安规考试（Electrical safety examination）.docVIP

电工安规考试（Electrical safety examination） Electrical safety simulation test paper E Attachment: the following is 09 years an electrician operation certificate exam and reference answers, Single-phase selection question 1, the overhead line zero line grounding repeatedly with ________. A. prevent electric shock, B. prevent leakage, C. improve overhead line lightning protection performance, D. above is wrong 2, three-phase symmetrical AC load, star connected to the phase voltage of 220 volts power supply. Known, the load current is 10A, the power factor is 0.8, the total power of the circuit ______ tile. A. 5280, B. 3048, C. 1760 Read 3, alternating current clamp meter on the current value is ___. A. maximum value, B. instantaneous value, C. average value, D. valid value 4, bus coloring has unified regulations, which provides V line color for ______. A. yellow, B. green, C. red, D. black 5, power equipment (power supply) isolation switch should be used ______. A. C. B. AC contactor switch in low voltage circuit breaker switch D. oil switch 6, low voltage distribution device back channel width shall not be less than ____M. A. 0.8, B. 1, C. 1.5, D. 2 7 fires, electrical equipment, should be the first _____. A. use non conductive fire extinguisher to save B., disconnect oil switch or automatic switch, D. disconnect disconnecting switch 8, a single-phase power supply circuit, and voltage loss through the calculation results, should not be less than the requirements of 3mm2 wire wire section, therefore should choose ___B____mm2 A. 3, B. 4, C. 5, D. 6 9, high pressure equipment in the uncharged case, ______ electrical personnel removed or work alone across the block. A. does not allow B. to allow C. without specific provisions D. above is incorrect 10, as _______ thermal relay protection apparatus. A. short circuit, B. motor overload, C. overload, D. motor phase loss 11, 220V, 40W L1 to 220V lamp circuit, 36V 40W, the light received on a 36V circuit is ________. A. L2 is bright