电控柜的安装注意事项（Cabinet installation note）.docVIP

电控柜的安装注意事项（Cabinet installation note） In 2007 08 the installation cabinet on Tuesday 28 June 15:04 cabinet installation 1. electrical equipment should have enough electrical clearance and creepage distance to ensure the safe and reliable work of the equipment 2. the installation of electrical components and assembly panels shall be considered as far as possible. 3. if possible, installation of fastener elements should be made in the front fastening and szantho. 4. each electrical component shall be individually disassembled and replaced without affecting the fixation of other components and wire bundles. 5. heating element should be installed in a good cooling place between two heating elements will be used for the connection conductor or bare copper porcelain tube. 6. diode, triode and thyristor, silicon stack and other power semiconductors should be installed in the vertical direction of its radiating surface or heat sink, so as to dissipate heat. 7. resistors and other electrical components should be installed in the box above the installation direction and location should be taken into account in favor of heat dissipation and minimize the impact of other components of the heat. 8. the electronic components in the cabinet should be kept away from the main circuit, switch power supply and transformer, and shall not be placed directly or near the convection direction of other heating elements in the cabinet. 9. master control electrical components and electrical components of the tuning arrangement should be avoided due to accidental touch and handle, button misoperation or action changes the value of the possibility of setting device in the general setting should be completed after the double nut and red paint seal, so as not to move. 10. system or different work voltage circuit fuse should be arranged separately. 11. fuses, parts that are easy to damage in use and need to be adjusted and reset occasionally, shall be accessible without removal of other components