电梯学习（Elevator learning）.docVIP

电梯学习（Elevator learning） Fill in the blanks: 1. if the door open limit in action before contact is closed, the input type TX0, TX1 should be set to 1, then if the door has been closed, DC voltage with a multimeter measuring car plate SM-02-D JP5.02 of JP5.01 0V shows, JP5.03 should show 24V to JP5.01. The 2. door system is composed of car door, floor door, door opener, door lock device, etc.. 3. if a given brake voltage is DC24V and the current is 6A, we should think of 1. The brake winding transformer capacity, 2. The line diameter of the brake path, 3. Electric shock capacity of braking path. 4. when emergency electric operation, the limit switch, the speed limiter switch, the safety switch and the buffer switch shall be out of order. If there are 5. parking brake drag phenomenon when the elevator is in turn, hold on brake, brake delay time should be adjusted to the motherboard 6. when the overhaul, the car top overhaul switch should be prior to the room overhaul switch 7. the balance coefficient of elevator should be between 0.4----0.5. 8. the unlocking area is a section of the upper and lower reaches of the platform when the bus stops. In the automatic operation, the car door through the door knife to drive the hall door open and closed. 9., car top overhaul, that is, emergency stop switch with protective ring because it is wrong to touch the switch 10. the limit protection switch on the upper and lower ends of the hoistway shall be moved before the limit switch is moved or the car or the switch of the counterweight switch is moved. 11. a total of 17 layer elevator, 2 floor without stop and floor spacing of 1 to 3 floor is 5 meters, then from the economical point of view, do you think the site should be installed 16 flat layer magnetic isolation board, car control box is equipped with 2 block plate. 12., there is a customer designated DP-01-A board, and its floor is 8 layers, then its configuration expansion board is B board and C board 13. there is a control cab