电脑检测顺序（Computer test sequence）.docVIP

电脑检测顺序（Computer test sequence） Please check the test according to the following method 1, first of all, check the electrolytic capacitor on the motherboard is not bulging phenomenon, if there is, you need to replace the capacitor. 2, if not, it is estimated that your computer power supply output is not enough. The computer appears difficult to start, the boot process crashes, restart automatically. In the long time after shutdown, usually the host power supply may be a problem, because the minimum requirements of several groups of the output voltage of the power supply has just reached the motherboard, the voltage drop caused by electricity in the computer just start, the computer cannot start normally, or the next boot again many boot, because the first boot hardware have done some charging, low electricity consumption can be a normal start. You can test this, if your computer has hardware like a drive, floppy drive, or burner, disconnect the power cord and reduce the power. If so, change the power supply. Computer does not start fault diagnosis and treatment Know the process of starting a computer In many computer failures, unable to start properly is the most user headache. The author has long been engaged in the maintenance of computer work, and has accumulated some experience in this field. Now I will sort out these experiences and share them with my friends. This article will be based on home computer and Windows98 operating system, introduced the computer can not properly start the diagnosis and treatment of failure. In order to accurately diagnose the computer does not start trouble, first to understand the process of starting, when we press the power switch, the power to the motherboard and other equipment of the power supply, the voltage is not completely stable, motherboard control chipset based on CMOS in CPU frequency setting sends a Reset to CPU (reset) signal. Let CPU initialization voltage completely stable after the chip group removed Reset signal,