ttl和cmos（和CMOS TTL）.docVIP

ttl和cmos（和CMOS TTL） TTL level TTL level signal is used at most is usually because of data representation using binary rules, +5V is equivalent to logic 1, 0V is equivalent to logic 0, which is called TTL (transistor transistor logic level) signal system, this is the standard communication technology between computer processor control equipment parts. Data transmission of TTL signal processor for computer control equipment inside is ideal, the first computer data transmission processor control inside the equipment is not high for the power supply and the heat loss is low, the other TTL signal directly with the integrated circuit without the need for expensive line driver and receiver circuit; moreover, the internal device data transmission computer processor control is performed in high speed, and TTL interface operation can meet this requirement. TTL type communication uses parallel data transmission in most cases, while parallel data transmission is not suitable for distances of over 10 feet. This is due to the two sides of reliability and cost. Because of the presence of bias and asymmetry in parallel interfaces, these problems have an impact on reliability. In digital circuits, the level used by a circuit consisting of TTL electronic components. The level is a voltage range, which specifies the output high level 2.4V and the output low level 0.4V. At room temperature, the general output is 3.5V high and the output low is 0.2V. Minimum input high and low: input high level =2.0V, input low level =0.8V, noise margin is 0.4V. Full name in English: transistor, transistor, logic The full name is the TTL integrated circuit transistor transistor logic integrated circuit (Transistor-Transistor Logic), mainly 54/74 series standard TTL type TTL (H-TTL), high speed, low power TTL (L-TTL), TTL (S-TTL), Schottky type low power Schottky type TTL (LS-TTL) five series. Standard TTL input high, minimum 2V, output high level minimum 2.4V, typical value 3.4V, input low level, maximu