差速器间隙调整（Differential clearance adjustment）.docVIP

差速器间隙调整（Differential clearance adjustment） It depends on the specific circumstances! Let me show you the way! When the meshing mark end bias, close to the driven gear to the driving gear, the driving gear backlash if will move outward; when the meshing mark small end, the driven gear from the driving gear, if the gap is too large, the driving gear shift; when the meshing mark partial to the addendum, active close to the gear driven gear, if the time gap is too small, it will move outwards when the driven gear meshing tooth; mark bias, driving gear driven gear to move, if the time gap is too large, it will be driven inward closer to eat. Summed up a jingle gear moving direction: from the root, the main; small out from top into the main roof; in the main, small from the root; in the Lord, from. Look at the map Indonesia on the line, the main thing is to see the contact surface of the driven gear and driving gear to adjust the adjustment, if not wear will be very powerful. Bearings can not adjust the gap, are driven by the driving gear and driven gear moving back and forth to adjust the differential. Its also an important technique in the car repair! Ha-ha！ ~ ~ First of all, to adjust the preload of the bearing, that is what you call the bearing clearance. Adjust to flexible rotation, no stuck phenomenon, no gap feeling. The clearance between the two bearings is adjusted by the shim between the bearings of the driving bevel gear, and the clearance between the shim and the bearing is large, and the backlash between the two bearings is reduced. The driven bevel gear (basin tooth) is adjusted with adjusting nut. With the adjustment of the gear contact area of Indonesia is correct, the gear clearance is appropriate. When the meshing mark end bias, close to the driven gear to drive gear, if the backlash will drive gear meshing mark when moving outward while the small end, the driven gear from the driving gear, if the gap is too large, the driving gear shift; mobile driven g