建筑幕墙入门知识（Knowledge of building curtain wall）.docVIP

建筑幕墙入门知识（Knowledge of building curtain wall） Curtain wall knowledge I. The design of rainproof and water leakage for curtain walls shall meet the following requirements: 1. the curtain wall should be designed according to the principle of equal pressure in the form of columns and beams. 2. unit curtain wall or curtain wall should have vent. Indoor drainage devices should be adopted in areas with frost; No frost areas, drainage devices may be outdoors, but there should be wind protection device. The outer surface of stone curtain wall should not be drained. 3., the use of silicone free weather sealant design, must have reliable measures to prevent wind and rain. The main design in this article is the design of waterproof and seepage measures. Firstly, the principle of isobaric design is considered, The so-called isobaric principle is through a variety of channels so that water can enter and out, as long as there are water, seam, pressure difference exists, there will be leakage of water problems. At present, many units adopt double channel sealant and waterproof measures combined with sealant are feasible, the requirements of the section relaxed. The principle of open fan constant pressure is still to be applied accurately, otherwise it will leak. In addition, the quality of hardware parts and switch mode is also one of the causes of leakage, Adequate attention should be paid to. At present, foreign countries have paid attention to it, and domestic research and development of hardware parts have been started, and the quality has also improved. Two. In the curtain wall of different metal materials contact place, in addition to stainless steel, should be installed heat-resistant epoxy resin, glass fiber cloth or nylon 12 gasket. Three. The steel frame structure of the curtain wall should be provided with a temperature deformation joint. Four. Wall insulation materials can be combined with the metal plate, stone together, but the surface and the main structure is 50 mm