水电安装及文明施工（Hydropower installation and civilized construction）.docVIP

水电安装及文明施工（Hydropower installation and civilized construction） The seventh chapter, mechanical equipment installation project I. General Situation of the project The project can be divided into: water supply and drainage works, heating engineering, ventilation and air conditioning works. Two, construction process 1 、 pipe installation Project content: installation of pipe line, support and hanger, dry pipe, vertical pipe installation, branch pipe installation, valve installation, accessory installation, corrosion protection and insulation. Avoid pipeline: water supply, heating pipe for drainage pipes, heating pipes to make water, let the small diameter of large diameter pipeline, pressure piping for non pressure piping, must be reasonable allocation between the various processes, to determine and adjust the project into the pipeline and bracket position. (1) Guan Daosi answers: 1) wire feed pipe. 2) draw lines on the tube and break the line according to the sketch of field mapping. 3) the use of electric threading machine, DN25mm more than two times, long sleeve wire, tube end to pad. 4) pipe thread connection should be between the inside and outside the thread with appropriate packing, generally use white paint, oil hemp silk, also can use raw adhesive tape. 5) install threaded parts, should press the screwing direction once installed, not back. After installation, expose the 2~3 thread and remove the remaining padding. (2) pipe welding 1) when welding pipes, the pipe interface shall clear off rust, dirt and grease. 2) when the steel pipe is cut, its cutting cross section should be perpendicular to the center line of the pipe to ensure the concentricity of the pipe welding. 3) when the pipe wall thickness is above 5mm, the groove shall be cut to ensure full penetration. The groove forming can be used for cutting or welding groove machining, but should be cleared of debris and iron oxide, and with a grinding, until the metal is exposed to light 4) pipe welding, the t