cad常见问题集锦（CAD FAQ）.doc

cad常见问题集锦（CAD FAQ） 1.CTrl+N solution when invalid As everyone knows, CTRL+N is a new command But sometimes, CTRL+N appears the selection panel At this point, just set the settings in the OP option Operate: OP (options) - System - - there is a start on the right (A display, start dialog, B does not display the start dialog) When you select A, the new command is valid, and the reverse is invalid Sometimes we have problems like this For example, CTRL+C (copy), CTRL+V (paste), CTRL+A (Quan Xuan) and a series of commands related to the CTRL key will fail At this point, you just need to tune in to the OP option Operation: OP (option) - user system configuration WINDOWS standard accelerator (tick) WINDOWS standard accelerator tick, and CTRL key commands is effective, and failure 2. fill in invalid solution Sometimes filling will not fill out In addition to system variables that need to be taken into account You also need to check in the OP option OP - display application entity filling (tick) 3. when the election is invalid The correct setting for AD should be to continuously select multiple objects But sometimes, the continuous selection of objects will be invalid, you can only select the last selected object This can be resolved as follows Enter the OP (option) - Select - with the SHIFT key is added to the choice set (tick) With the SHIFT key is added to the choice set tick after add effective On the contrary, the selection is invalid The 4.CAD command three reduction If the system variables in CAD are unintentionally changed Or some parameters have been deliberately adjusted, what should I do? At this time, there is no need to reinstall, nor do you need one change at a time Operate: OP option - configuration Reset Can resume But after recovery, some options also need some adjustments, such as cross cursor size, etc. ~! 5. print preview print stamp on how to deal with? Print preview print stamp, check the print stamp printing equipment in but still does not work, do not