塑胶跑道（Plastic track）.docVIP

塑胶跑道（Plastic track） Plastic track How to write the construction procedures of the plastic runway? 2010-09-13 To clean the place bottom glue dosing, mixing, paving, defoaming and curing, surface glue dosing, mixing, paving, defoaming, and particles and recovery, glue, latex painting line, measuring detection point line, completed 2, the laying process description: (1) first of all, to check the smoothness of the base layer, leveling the concave and convex parts (for example, the cement concrete foundation needs pickling). (2) the bottom rubber laying: before laying the bottom rubber, first clean the foundation and prepare the tools for construction. A) according to the requirements of the process, measure the location of the construction line and put the construction line in place. B) starting from the side of laying site according to the site, the width of disposable frictioning. C) spreading speed is even, in time for the show, concave and convex of glue or scraping. D) after gluing, inspect the whole floor to ensure the thickness of the covering. (3) paving of surface adhesive: A) time interval frictioning when you try to reduce every barrel of glue, the gelation rate is uniform. B) observe the thickness of the adhesive surface at all times. (c) scrape the surface glue, sprinkle the red particles before the surface glue is solidified, and clean the excess colloidal particles when it is completely solidified. D) spraying, to ensure that the particle does not fall off. (4) process line: according to the current track and field facilities standards, accurately measure the location of the process line, then spray with polyurethane paint. Plastic runway type 1 、 printing type antiskid plastic runway First of all, the cement foundation should be waterproof treatment or asphalt foundation for the bottom sealing treatment. The base layer is processed after 24 hours of maintenance can be paved runway bottom, with plastic substrate according to GB doped with 25% 3-4mm in di