外贸镀锌丝相关描述(Related description of galvanized wire for foreign trade).docVIP

  • 2
  • 0
  • 约4.5千字
  • 约 7页
  • 2017-10-07 发布于河南
  • 举报

外贸镀锌丝相关描述(Related description of galvanized wire for foreign trade).doc

外贸镀锌丝相关描述(Related description of galvanized wire for foreign trade)

外贸镀锌丝相关描述(Related description of galvanized wire for foreign trade) 镀锌丝的原材料: galvanized wire and the other wire mesh are manufactured by wire rod. chengtong buy this material from shanxi zhongyang iron steel co., ltd, which is the biggest steel factory in china. the type of wire rod is q195, element composition is as follows: c≤ 0.07; s≤ 0.023; si≤ mn≤ 0.09; radiation; p≤ 0.025.because this type of wire rod has less impurities, q195 is fit for drawing. the diameter is 6.5mm. generally, daily output of chengtong is 120 tons. 镀锌丝的生产过程: 1.galvanized wires first stage is drawing. there are two kinds of drawing machine, drawing powder drawing and water. powder drawing is fit for junior drawing (6.5mm ~ 4.0mm). one powder drawing machine has four tanks and 4 molds. one tank is matched with a mold. each of them are offered energy by a electromotor. 0.9mm (max) can be eat when the wire cross to mold. there are no loss of weight during drawing. powder is used as lubricant, which is made of soap and butter. mold is hidden behind the powder. water draw is used for senior draw. ( 4.0mm), the container is filled with water, soap and 8 molds. compared with powder draw a draw can save lots of room and the wire cannot be broken. after drawing, the wire is thinner, but also very hard. the tool strength is about 700n. these wire can be used to produce nail and mesh panel. for galvanized wire, it still need annealing 2. galvanized wires second stage is anneal. anneal is to low the tool strength of wire. the stove is solid and built with red bricks. the architecture of anneal stove is cuboid. different thickness of wire require different temperatures. the range is from 700°c to 900°c. output of the anneal stove, the tool strength is 400n ~ 600n 3. galvanized wires third stage is chlorhydric acid washing. after the draw and anneal, the wire is thinner, softer but also much more dirty. it needs chlorhydric acid washing to remove the impurities. chlorhydric acid washing requires water po

文档评论(0)

1亿VIP精品文档

相关文档