扦插玫瑰花技术（Cutting rose technique）.docVIP

扦插玫瑰花技术（Cutting rose technique） Cuttings of roses can not let them germinate soon, because the branches do not have outside sources of nutrients, germination will consume nutrients in the branches, there is no nutrient used to take root. The essentials of cutting roses: (1) choose to enrich the disease-free branches: Have strong and healthy branches for cutting, a good beginning is half of success, so the pest branches should be avoided, and the development of full leaf hypertrophy leaves should be contained in the nutrient rich, cutting is more likely to succeed. (two) to prevent diseases and insect pests from invasion: In cutting cuttings, media, pots soil or in cutting environment, should avoid disease invasion, such as black mildew, branch blight disease, etc is very easy to occur in cutting, so proper use of fungicide is very necessary. (three) water management: Because the rose cuttings cut, has been unable to get water supplement from mother plants, so give sufficient water to avoid withering, generally require quantitative timing water supply and simple greenhouse above facilities to commercial production, water control should pay attention to moisture and air medium in the humidity. In order to maintain the moisture and leaves with thin wet principle. (four) rooting agent was used to promote rooting: IBA1000-2000ppm can help rose rooting, attention must be paid to the high concentration but will make the cuttings without axillary bud Yi Mengfa, so in order to make appropriate concentration of cuttings rooting well, in addition to the above-mentioned points are essential methods and procedures as well as the propagation of rose cuttings to pay attention to things. (five) other matters needing attention: The middle section of cut flowers is more suitable for cooperative cuttings. The cuttings of 3 leaves and 3 leaves are faster than single ear cuttings, but the cost is higher. The cuttings medium can be mixed with peat soil and Pearl stone. In order to promot