摘录4（Excerpt 4）.docVIP

摘录4（Excerpt 4） Processing, as shown in the parts, the blank is 80mm * 80mm * 19mm rectangular block (80mm * 80mm, four sides and the bottom have been processed), the material is 45 steel. 1) upper surface processing program O1001; program name N10, G54, G90, G17, G40, G80, G49, G21; sets the initial state N20 G00 Z50; safe height N30, X-95, Y0, S300, M03; start the spindle and feed it to the lower tool position quickly N40 G00 Z5 M08; close to the workpiece and turn on the coolant N50 G01 Z-0.7 F80; knife down to -0.7mm, N60, X95, F150; roughing the upper surface N70 M03 S500; spindle speed 500r/min N80 Z-1; knife down to -1mm, N90, G01, X-95, F100; finish milling; upper surface N100, G00, Z50, M09; Z, lift the knife to a safe height and close the coolant N110 M05; spindle stop N120 M30; end of program 2) external contour, hole and cavity roughing program O1002; master program name N10, G54, G90, G17, G40, G80, G49, G21; sets the initial state N20 G00 Z50; safe height N30 G00, X12, Y60, S400, M03; start spindle, fast feed to lower tool position (point 1, see above) N40 G00 Z5 M08; close to the workpiece and turn on the coolant N50, G01, Z-7.8, F80; lower knife N60, M98, P1011, D01, F120, tone program, O1011, rough machining outline N70, G00, X1.7, Y0; quick feed into the hole, the knife position N80, G01, Z0, F60; approaching artifacts N90, G03, X1.7, Y0, Z-1, I-1.7; screw down knife N100, G03, X1.7, Y0, Z-2, I-1.7; N110, G03, X1.7, Y0, Z-3, I-1.7; N120, G03, X1.7, Y0, Z-4, I-1.7; N130, G03, X1.7, Y0, Z-5, I-1.7; N140, G03, X1.7, Y0, Z-6, I-1.7; N150, G03, X1.7, Y0, Z-7, I-1.7; N160, G03, X1.7, Y0, Z-7.8, I-1.7; N170, G03, X1.7, Y0, I-1.7, trimming hole bottom N180, G01, Z-5.8, F120; lifting knife N190 G01 X10 Y0; feed point 1 (see above) N200, M98, P1012, D01, tone program, O1012, roughing chamber N210, G00, Z50, M09; Z, lift the knife to a safe height and close the coolant N220 M05; spindle stop N230 M30; the main program is over 3. External contour processing sub