数控对刀法（Numerical control method）.docVIP

数控对刀法（Numerical control method） First, try cutting the tool directly with the cutter 1. use external garden tool to test an outside garden, remember the current X coordinates, measure the diameter of the outer garden, use X coordinate to reduce the diameter of the outside garden, and enter the value of the geometry of the offset interface, X value. 2. use the outside lathe tool to test an outside end of the garden first, remember the current Z coordinates and enter the geometry Z value of the offset interface. Two, set the zero of the workpiece with G50 1. use the outside lathe tool to test an outside garden first, measure the diameter of the outside garden, then return the knife along the positive direction of the Z axis, and cut the end face to the center (X axis coordinate minus diameter value). 2. select the MDI mode, type G50 X0 Z0, start the START key, and set the current point to zero. 3. select MDI mode, enter G0, X150, Z150, so that the tool from the workpiece feed processing. 4. at this time the program begins: G50, X150, Z150...... . 5. note: with G50, X150, Z150, you start and end must be consistent, that is, X150 Z150, so as to ensure repeated processing is not a knife. 6., such as the use of second reference point G30, that is, to ensure repeated processing without chaos knife, then the program begins with G30 U0, W0, G50, X150, Z150 7. in the FANUC system, the location of the second reference points in the parameter settings, in the Yhcnc software, press the right mouse button dialog box, click the left mouse button to confirm. Three, set the zero of the workpiece by moving the workpiece 1. in the Offset of the FANUC0-TD system, there is a workpiece moving interface that can enter zero offset values. 2. use an outside lathe tool to cut the end face of the workpiece, then the position of the Z coordinate, such as Z200, is entered directly into the offset value. 3. select the Ref back reference point mode, press X and Z axis back reference point, then t