消防系统（Fire protection system）.docVIP

消防系统（Fire protection system） Fifth intelligent fire fighting system Fire system First, the intelligent fire control system The intelligent degree of the intelligent fire fighting system involves many factors, including and implementation of information communication between the design and selection of fire detector and signal processing circuit of the detector and the selection of the controller, and the fire detection and alarm and fire linkage control equipment, and improve the intelligent fire-fighting system is the key problem of fire information judgment and treatment. The identification methods of fire detector output include threshold comparison mode, alarm threshold automatic floating mode and distributed intelligent mode. The method of fire pattern recognition with higher intelligence has been applied in a few large and medium-sized fire protection systems. (1) threshold comparison The threshold comparison method is widely used in fire detectors, and is also the earliest method of fire information processing. At present, the widely used addressable switch fire alarm system, response threshold, automatic floating fire alarm system are compared using threshold. As shown in Figure 7-21, a thermal smoke composite fire detector schematic using a threshold comparison method. The smoke sensing mode adopts the scattering type photoelectric smoke sensing mode, and adopts the double pulse two times synchronous comparison work mode. When the smoke, a light receiving element receives the infrared smoke there; when the photosensitive current output is proportional to the smoke concentration, if the two pulse cycle time, the photosensitive amplified output signal is higher than the set threshold, an alarm will be generated output. This threshold can be set smaller to allow for higher sensitivity to be used as early fire detection. The temperature sensing detector adopts the thermistor type constant temperature detection, and the 65oC action is used to confirm the linkage