pppoe报文（PPPoE message）.docVIP

pppoe报文（PPPoE message） The discovery phase of 2010-01-06 09:04PPPOE can be divided into four steps. In fact, this process is also a process of exchanging four kinds of data messages of PPPOE. When these four steps are completed, both the user host and the access concentrator can learn the MAC address and the unique session ID number of the other party, And then move on to the next stage (session phase of PPPOE). In fact, after knowing each others MAC address, the two parties have already identified a one-to-one correspondence on the broadcast network, in order to ensure the validity of this connection The PPPOE protocol can be used more flexibly, so the session ID field is added. Through the two conditions, the relation between the two nodes can be determined. At this stage, at first, since access users do not know the MAC address of the concentrator access, the MAC address of the concentrator is accessed using a mechanism similar to the ARP parsing process. First, an initial broadcast message is initiated by the access user side And if you configure PPPOE access concentrator for business, it will be real time detection of network data packets, when carrying Ethernet data frames are PPPOE messages (separated by protocol domain content), will be handed over to the corresponding Module processing. When an initialization message is received, the access concentrator responds to a message to the user. If there are many such access concentrators on the network and receive the initialization messages sent by the user side, they will also be on the side of the user Send a confirmation message. If the user receives this message, it will select a unique access concentrator for the session based on what is contained in the message or some of the configuration at the end. By this time, the first two steps have been completed, and the remaining two The step is to negotiate some of the service options provided and get the session ID value necessary for the PPPOE session phase. At