富士变频器故障（Fuji inverter fault）.docVIP

富士变频器故障（Fuji inverter fault） Fuji inverter fault,.Txt people never know who inadvertently told you goodbye, then really gone. How long is a minute? It depends on whether you are squatting in the toilet or waiting outside the toilet...... Reason analysis of common alarm of Fuji inverter (1) OC alarm (plus, minus, constant speed, overcurrent) For a short time and high current OC alarm, the general case is the drive plate current detecting circuit module is out of the question, may have been affected by shock (damage), resulting in the reduction to failure, the reason is basically the following situation: the motor cable is too long, cable selection output leakage current caused by large or critical output cable and cable joint loosening damage caused by load current rises from the arc effect. Short capacity (less than 7.5G11) converter 24V fan power supply short-circuit will also cause OC3 alarm, at this time the main board of the 24V fan power supply will be damaged, the motherboard other functions are normal. If the 1 and OC2 alarm, and can not reset or a power on the display OC3 alarm, it may be the motherboard out of question; if a press RUN button to display OC3 alarm, it is the driver plate damage. (2) OLU alarm (frequency converter over load); When the G/P9 series inverter this alarm can be solved through three methods: first, revise the torque and deceleration time and energy saving operation parameters; second inverter output measurement is really too large; then observe the left corner of the motherboard detection output with an oscilloscope, to judge the motherboard it has been damaged. (3) OU1 alarm (acceleration over-voltage); When the general inverter OU alarm, should first consider whether the cable is too long, the insulation is aging, electrolytic capacitor middle DC link is damaged, at the same time for the large inertia load can be considered to do on-line self-tuning of motor. In addition, at the start of the multimeter to measure the middle DC lin