弧线技巧（Arc technique）.docVIP

弧线技巧（Arc technique） Arc points In rod ball, to consider several factors, which will be a factor as a benchmark, the other as a reference. Second is the distance, is the cue ball and the target ball distance, it must have the accurate estimation. Fourth is the side bar, the lower right corner is the white ball, rod point selection scope is too large, we have the two benchmark to limit it, the first one is the partial point on the rod level vertices, which side spin on the left or right of the vertex, in other words it side rod. The second one is to place the bar at the lowest point, slightly to the other side, and at the bottom where it is slightly left or slightly right. In other words, it is a low bar point. Now let me talk about my experience with these two benchmarks The value of the horizontal rod at the deflection bar The horizontal distance range of the cue ball and the target ball rod angle linear distance range and target ball ball 30141~16220 to 24 40143~16428 to 34 50134~16934 to 55 55126~17540 to 7 60156~17069 to 80 65123~14255 to 80 7093~12848 to 80 7590~11352 to 80 8094~11065 to 80 The numerical value of the horizontal rod at the low bar level The horizontal distance range of the cue ball and the target ball rod angle linear distance range and target ball ball 50134~16034 to 63 55119~10746 to 57 6089~5139 to 41 6567~3629 to 36 7038~8524 to 30 7517~8214 to 19 807~817 to 11 These data are based on a pole and base: parallel when measured, if the rod line is blocked should identify obstacles to the ball, rod line according to the actual situation, determine the rod line process, the first is to find out an imaginary ball arc can bypass the barriers. The second is the theoretical curve in comparison with this imaginary line, to find out the most close to the arc, as I said above nine partial pole arc (small radian) and seven low rod arc (big radian, backspin), ha ha, this you should often practice to grasp these arcs. The third is to determine the horizontal