桥梁电算计算书.doc

唐 山 学 院 毕 业 设 计 设计题目：建工程4桥梁结构设计 系 别： 土木工程系 班 级： 班 姓　 　名： 指 导 教 师： 2014年月 丰润北环新建工程4号桥结构设计 摘要 本桥跨越老还乡河，属丰润北环新建工程4号桥。上部结构为装配式部分预应力混凝土箱形连续梁，跨径布置3X25m,下部结构采用桩柱式墩台。桥梁横截截面为双向四车道，双幅桥每幅宽12.75m,桥面横坡2%。 本设计属于结构验算，主要对设计好的箱型连续梁上部结构进行施工和使用阶段安全验算，利用桥梁博士软件进行建模，输出计算结果并进行调束，使得截面内力和应力满足规范要求，最后画出修正后梁的构造图和配筋图。设计目的是熟悉装配式预应力箱梁连续梁桥的施工工艺及施工到成桥验算指标，熟悉桥梁博士的建模过程并判别输出验算结果正误，进一步熟练掌握桥梁CAD软件，为以后从事桥梁施工和设计工作打好基础。 关键词：先简支后连续 桥梁博士 横向分布系数 桥梁CAD Fengrun North Central New Project 4 Bridge Structural Design Abstract The bridge supposes for the cross LaoHuanXiang river,which belongs to Rich North Central New Project on the 4th bridge.The superstructure is composed of fabricated parts of prestressed concrete continuous box bridge and the span arrangement is (3X25)m. Column pier pile is used to constitute the substructure. The form of Cross-section is Two-way four-lane，which is embodied by Double width bridge.Each width is 12.75m and bridge cross slope is 2%. This thesis is classified to structure checking,which main point is to check Structural Safety during Construction Phase and Use phase by the Doctor Bridge .After output results is checked ,Steel Beam is turned until the requirements of internal forces and stresses is met.Then structural map and diagram of the beam reinforcement is drew according to the results .The aim of design is to know well about the process of construction technology and checking project.Modeling process and Modification of results can be learned .Moreover ,further proficiency of bridges CAD software can be exercised in the process of design. Keywords: Simple Support and Continuous Doctor Bridge Transverse distribution coefficient Bridges CAD 目录 1 引言 1 2 验算模型及参数 1 2.1结构介绍 1 2.2 计算方法 2 2.3 计算采用规范 2 2.4 计算采用标准 2 2.5结构验算参数 3 2.5.1 计算要点 3 2.5.2 结果参数说明 4 2.5.3 横断面布置 4 2.5.4跨中计算截面尺寸及几何特性 4 2.5.5汽车荷载横向分布系数 5 2.5.6汽车荷载冲击系数值计算 6 2.5.7 荷载 6 3 中梁第1施工阶段应力验算