充型速度对半固态alsi9mg组织及性能的影响-河北科技大学学报.pdfVIP

32 2 Vol. 32, No . 2 20 11 4 Journal of Hebei University of Science and T echnolo y Apr . 20 11 : 1008- 1542( 2011) 02-0173- 04 AlSi9M 谭建波, 刘 冉, 郝跃光 ( 河北科技大学材料科学与工程学院, 河北石家庄 0500 18) : 采用倾斜冷却剪切流变法制备半固态AlSi9M 金熔体, 流变压铸标准力学性能试样并 进行了力学性能测定, 用定量金相技术对力学性能试样的初生固相微观组织特征参数( 固相率晶 粒尺寸和形状因子) 进行了分析, 研究了充型速度对半固态AlSi9M 金组织及性能的影响研 究结果表明: 随着充型速度的提高, AlSi9M 金组织的初生固相率和形状因子先增大后减小, 晶 粒平均直径先变小后变大, 力学性能也发生很大变化, 布氏硬度随充型速度的增大而增大, 但抗拉 强度和冲击韧性分别增大到275 MPa 和 129. 8 kJ/ m2 后又开始下降本实验条件下 理的充型 速度为1. 9 m/ s 左右 : 充型速度; A lSi9M ; 微观组织; 半固态; 力学性能 : T G146. 4 : A Influence of fillin velocity on sem-i solid microstructures and properties of AlSi9M alloy TAN Jian-bo , LIU Ran, HAO Yue- uan ( Colle e of Material Science and En ineerin , Hebei University of Science and T echnolo y, Shijiazhuan H ebei 0500 18, China) Abstract: Semi-solid AlSi9M alloy melt and correspondin standard test specimens w ere prepared by rheo-diecastin process on incline coolin and shearin bench. Then the specimens w ere tested on their mechanical propert ies. T he characteristic pa- rameters of primary solid phase ( includin solid fraction, diameter of rains and shape factor) w ere analyzed throu h quantita- t ive metallo raphic techniques. T he influence of fullin velocity on the sem-i solid microstructures and properties of AlSi9M were researched into. The results show that : the primary solid fraction and shape factor of AlSi9M alloy first increase and then decrease, and the avera e diameter